Product number: Lxj530S
Product: Sterling Silver anti electromagnetic shielding coating
Packaging specification: 1KG/barrel 5KG/barrel 10KG/barrel 15KG barrel 20KG/barrel?
Product Introduction: LXJ530SSterling Silver electrically conductive wave shielding coating is an Aqueous conductive paint produced by Shenzhen Lixinjia Technology Co., Ltd. It is made of conductive silver particles and can be diluted directly with water, which is green and environmentally friendly. Conductive paint. Single component, labor-saving, time-saving, convenient, with excellent adhesion, smoothness, strong cohesion, and no loose particles, it can be used for mobile, calculators, precision instruments, medical devices and other shell inner wall spraying materials with composite materials as the substrate. After drying and curing, the paint layer has stable performance and is suitable for single piece batch spraying factory production. At the same time, just spraying a thin layer will have good conductivity.
Product properties Conductive material: Silver particles (khaki)
Binder: Thermoplastic (when the original barrel comes)
Solid composition (%): 35 ± 2
Theoretical coverage area: 10-12m2/kg
Shelf life: The original barrel can be stored for 12 months
Volatile component: approximately 650g/kg (when spraying)
Suggested film thickness: should be 10 μ M (dry film)
Conductivity: 0.015 Ω/cm2/10 μ M
Electromagnetic noise attenuation: 70-80db
Mixing and diluting LXJ530S is easy to stir and shake well. Use an oil shaker to shake for 5 minutes. To shake well, check that there is no more sediment at the bottom of the barrel (especially when stirring manually), use LXJ3700S diluent with a dilution ratio of 1:0.5
Spraying method: This coating can be sprayed using traditional spraying equipment, or using low air pressure and high spraying volume equipment to achieve better results and save paint. It can also be sprayed using a fully automatic robotic arm.
After the spray film has dried and solidified, there are 15 μ The thickness of m only has sufficient resistance to dryness, but depending on the actual requirements of the user in terms of anti-interference, the coating film can be thinner. When spraying, it is necessary to pay attention to dry spraying, as dry spraying can cause insufficient adhesion and roughness of the coating film.
The surface of the spray piece must be clean and dry.
After dry spraying, dry naturally for 5 minutes, and then bake at 71 ℃ (1600F) for 30 minutes.
Safe use: If accidentally swallowed, inhaled, or penetrated through the skin, this product is harmful to the human body and can cause harm to the eyes. After using this product, it must be cleaned and washed to remove contamination. When storing this product, it must be kept away from heat sources and areas where there is a chance of static sparks, and should not be near open flames. When not in use, the container should always be tightly closed, and air circulation must be maintained during use. Do not inhale volatile gases.
