LXJ500Sterling Silver electro magnetic wave shielding coating is a conductive paint produced by Shenzhen Lixinjia Technology Co., Ltd., which is made from conductive silver particles. Single component, labor-saving, time-saving, convenient, with excellent adhesion, smoothness, strong cohesion, and no loose particles, it can be used for mobile, calculators, precision instruments, medical devices and other shell inner wall spraying materials with composite materials as the substrate. After drying and curing, the paint layer has stable performance and is suitable for single piece batch spraying factory production. At the same time, just spraying a thin layer will have good conductivity.
Product nature:
Conductive material: silver particles
Binder: Thermoplastic (when the original barrel comes)
Resistance:<0.05 Ω/L 17 μ M (dry film)
Solid composition (%): 35 ± 2
Theoretical coverage area: 10-12m2/kg
Shelf life: The original barrel can be stored for 12 months
Volatile component: approximately 650g/kg (when spraying)
Suggested film thickness: should be 10 μ M (dry film)
Conductivity: 0.015 Ω/cm2/10 μ M
Electromagnetic noise attenuation: 70-80db
Mixing and Dilution
LXJ500 is easy to stir and shake well. Use an oil shaker to shake for 5 minutes. To shake well, check that there is no more sediment at the bottom of the barrel (especially when stirring manually), use LXJ3700 diluent with a dilution ratio of 1:0.5
Spraying method
This coating can be sprayed using traditional spraying equipment or using low air pressure and high spraying volume equipment, which will have better results and save paint. It can also be sprayed using a fully automatic robotic arm. After the spray film has dried and solidified, there are 15 μ The thickness of m has sufficient anti drying ability, but depending on the actual requirements of the user in terms of anti-interference, the coating can be thinner. It is necessary to pay attention to dry spraying during spraying, as dry spraying can cause insufficient adhesion and roughness of the coating film
The surface of the spray piece must be clean and dry.
Dry fixation
After spraying, dry naturally for 5 minutes, and then bake at 71 ℃ (1600F) for 30 minutes.
Safe and applicable
If accidentally swallowed, inhaled, or penetrated through the skin, this product is harmful to the human body and can cause harm to the eyes. After using this product, it must be cleaned and washed away to remove contamination. When storing this product, it must be kept away from heat sources and areas where there is a chance of static sparks, and should not be near open flames. When not in use, the container should always be tightly closed, and air circulation must be maintained during use. Do not inhale volatile gases.
